MIMORAD 4G / 5G Antenna 5dBi Peak Gain for TCR100 4G Router

£55.00

MIMORAD Outdoor 4G Antenna connects to the antenna ports of the Teltonika TCR100 router and the antenna can be located outdoors where there is a better 4G network signal.  The MIMORAD 4G antenna is pre-terminated with 2 x 5m long cables with SMA Male antenna connectors.

The MIMORAD antenna is a high gain, outdoor 4G antenna that covers the UK 3G, 4G and 5G mobile network frequencies.

The Fullband® MIMORAD® outdoor antenna works with the Teltonika TCR100 in situations where the 4G router is located indoors where there is a poor 4G network signal, but there is a much better 4G network signal outdoors.

The Mimorad antenna is supplied pre-terminated with 2 x 5m long cables with SMA antenna connectors which will screw directly to the antenna ports on the rear of the TCR100 router.  If your router is more than 5m away from where you want to locate the antenna, then you can purchase pre-terminated antenna extension cables in 5m and 10m lengths.  We recommend that you try to keep the 4G antenna cables as short as possible due to signal loss along the length of cable.

If your TCR100 router is located far away from where you want to install the antenna, then consider the option of moving the router closer to the antenna and extending the LAN side of things.  You could run a long Ethernet cable (up to 100m) from the router to a network switch or WiFi Access Point.  This means that the 4G modem is closer to the antenna so there will be less signal loss and better performance.

Fullband® MIMORAD® is an omni Directional, high performance wide band antenna that has twin connector cables to connect to the MAIN and AUX ports of 3G and 4G routers.

It is a Fullband Antenna which means that it works with all UK 2G, 3G and 4G mobile network frequencies so can be used with all of our 3G and 4G routers that have a MAIN and AUX antenna connection.

It is fully weatherproof so can be positioned outdoors in the optimum position to capture the best 3G/4G signal and deliver it to the connected device and its vertical beam width and Back to front ratio ensure that it will deliver the best performance at all times.

The Peak Gain of this MiMo antenna is 6dBi and the antenna can be wall or pole mounted.

The MIMORAD® antenna is pre-terminated with 2 x 5m long antenna cables terminated with SMA Male connectors to fit directly to the antenna ports of your 3G or 4G Router. If you need to extend the cable length then remember you will need to purchase two antenna extension cables. Please also remember that if you are using antenna extension cables that your extended cable length will depend upon the signal strength of the mobile network at the antenna location. If your signal strength is excellent then you can extend up to 15m to 20m but if the signal strength at the antenna location is only good or medium then your maximum cable length should be shorted at perhaps just 10m.

Frequency 800-960/1710-2600MHz (also supports NEW 5G Mobile 2700Mhz and 3500Mhz)
Central point 800/1800/2600MHz
VSWR 2.0
Peak Gain 6dBi
F/B radio 8dBi
Polarization Type Vertical
Vertical beam width 800-960MHz—40-60°, 1710-2600MHz–14-32°
Rated Power 100w
Input Impedance 50?

Physical
Connector Type SMA Male x 2
Cable type SSF50 5m long x 2
Operation temperature -40 to +70 Celcius
Water proof level IP67
Mounting method U bolt
Dimensions 70mm Diameter x 350mm height
Radome Material PVC
Weight 1.5Kg

Reviews

There are no reviews yet.

Be the first to review “MIMORAD 4G / 5G Antenna 5dBi Peak Gain for TCR100 4G Router”

Your email address will not be published. Required fields are marked *

Your Cart

Cart is empty

Subtotal
£0.00
APPLY
0